
Running Hydration Salts: What Actually Matters
Most runners start thinking about salt when they see it — white lines dried onto a black running top, a pale crust around the temples, the particular thirst that plain water doesn't seem to fix. By then, the signal has already been sitting there through multiple training sessions, unread.
Running hydration salts matter. But the conversation around them is often pulled in two directions that are both wrong: either sodium is treated as an afterthought, or it's pushed to dramatic, performance-marketing levels that don't reflect the physiology of most endurance athletes.
The answer sits in the science. Understand what sweat actually contains, what replacing it actually requires, and the plan gets much simpler.
"When we were building the electrolyte formula, the question that kept coming back was: what do athletes actually need, versus what do brands typically give them? The gap was significant. Products with 1,000–1,500mg of sodium per serving dominate the market. That dose is appropriate only for specific, high-sweat-rate conditions. For most runners in most sessions, it's excessive — and the side effects are real. We went back to the sweat science from GSSI and NIH and built from there."
— Alistair Brownlee, Two-time Olympic Triathlon Champion and founder of truefuels
What sweat actually contains
Sweat is not just water. It contains sodium, chloride, potassium, magnesium and other minerals. Of these, sodium dominates the performance equation during running because of its role in fluid balance, nerve signalling, and carbohydrate absorption.
The numbers from the scientific literature (NIH sweat composition review; GSSI sweat testing data):
- Sweat sodium concentration typically ranges 20–80 mmol/L — equivalent to roughly 1.2–4.6g of salt per litre of sweat
- The commonly cited average sits around 2.5g salt per litre
- Most endurance athletes lose 0.5–1.5 litres of sweat per hour depending on conditions
From this, you can derive a sensible sodium target — not by copying a product's label, but by matching intake to realistic losses.
Why ~400mg sodium per 500ml is the physiologically correct target for most athletes
There is no scientific consensus that athletes need to replace 100% of sodium lost. Replacing approximately 80% of average sodium loss per 500ml of fluid is both effective and manageable — easier to plan, easier on the gut, and aligned with actual sweat physiology rather than marketing positioning.
That's the rationale behind the truefuels Active Hydration formulation: 390mg sodium per sachet, from 1g of Himalayan Rock Salt per 500ml. Not because a lower number is "easier to sell," but because that's where the science puts the optimal balance for most athletes in most conditions.
Electrolyte comparison by sodium content
| Product | Sodium | Potassium | Magnesium | Scientific alignment |
|---|---|---|---|---|
| truefuels Active Hydration | 390mg | 150mg (natural) | 25mg | Sweat-matched; no artificial sweeteners |
| High-sodium electrolyte brands | 1,000–1,500mg | 200–250mg | 0–70mg | Designed for heavy sweaters in prolonged heat; excessive for most sessions |
| Light electrolyte mixes | 300–400mg | 30–50mg | — | Mild sodium delivery; typically low in potassium |
Products with 1,000–1,500mg of sodium are not wrong in every context — they have a role for athletes with very high sweat rates during prolonged heat exposure. But they are not appropriate as a standard training or racing protocol for most runners, and the risks of sustained high sodium intake include GI distress, poor fluid balance and chronically elevated blood pressure.
The three variables that actually matter for your sodium plan
1. Sweat rate. More fluid lost per hour means more sodium lost. Estimate yours: weigh before and after a 60-minute steady run without drinking. Each kilogram lost is approximately one litre of sweat.
2. Sweat sodium concentration. Some athletes are much saltier than average. If you consistently finish runs with visible white salt lines on your kit or a salt crust on your face, your personal requirement is above the typical range.
3. Conditions. Heat and humidity increase sweat rate substantially. A plan that works for a cool 10km race will not be adequate for a warm marathon or summer triathlon.
Practical sodium targets by running scenario
| Scenario | Sodium target per hour | truefuels approach |
|---|---|---|
| Easy run, <60 min, cool | 100–200mg | Gel built-in electrolytes sufficient |
| Long run, 90+ min, mild | 300–500mg | 40/0.25 gel covers most needs |
| Tempo or race-pace, any | 400–600mg | 40/0.25 + 40/1.0 gel combination |
| Long run or race, warm | 500–700mg | 40/1.0 gels or gel + electrolyte sachet |
| Hot race or heavy sweater | 700–1,000mg+ | Gel + 1–2 electrolyte sachets; pre-load |
How sodium and carbohydrate are connected
This is the insight most hydration guides miss. Sodium doesn't just replace sweat losses — it actively enhances glucose absorption through the SGLT1 co-transporter in the intestine. When sodium is present alongside carbohydrate in the gut, glucose uptake increases, carbohydrate oxidation improves, and GI distress risk decreases.
This is why truefuels builds sodium into the Performance Gel itself, not as an electrolyte afterthought but as part of the delivery mechanism. The 40/1.0 gel provides 386mg sodium per serving alongside 40g of carbohydrate. Your fuel is absorbed more effectively when the electrolyte profile is correct. Getting hydration salts right isn't just about hydration — it's about whether your fuel actually gets to your muscles.
The mistake of more-is-better
The marketing pressure in the hydration salt category is towards higher sodium. Bold products, big numbers, "elite-level" dosing. It looks credible on a label. It isn't always appropriate for your session.
Taking 1,000–1,500mg of sodium in a short or cool training session when your actual sweat rate is modest:
- Creates an unnecessarily high osmotic load
- Can cause GI discomfort
- Drives thirst that leads to excessive fluid intake
- Does not meaningfully improve performance
The goal is accuracy, not maximalism. Match your sodium plan to your sweat losses. Know your own profile. Let the science — not the label — tell you what you need.
What actually matters
Salt matters in running hydration. But the variables are personal. Your sweat rate, sweat sodium concentration, the conditions you're training and racing in — these determine the right dose far more accurately than any product's default serving suggestion.
Start with the physiologically correct baseline: approximately 400mg sodium per 500ml of fluid, from a clean source without artificial additives. Test in your actual conditions. Adjust based on what you observe — weight change, performance quality, thirst patterns, salt marks. Then build a protocol you can repeat.
When hydration is precise, everything else in your race nutrition functions better. That's what makes sodium worth understanding rather than guessing.

